The easiest method is to watch the computer count up the memory when the machine is turned on. If you do not see the count, or you have a Mac, you can check it once the operating system is loaded. Mac users can check the "About This Macintosh" o...
No. RAMBUS based systems with memory installed in pairs must always have the memory installed in pairs.
Unless your computer's owner's manual says that is a valid configuration, you cannot install mismatched memory modules into the computer.
Most computers have a similar memory installation procedure - notebooks and desktops alike. Notebook computers usually have a compartment located on the bottom of the unit where the memory is installed. After unplugging your computer from its power source...
No. RAM is a basic system component and you will not have to do anything to tell the computer the RAM is installed. First, reseat the memory. Check to make sure you have the correct module for your computer. Try reordering the memory in the sockets. On a ...
Yes, but no more than a second or two longer. The computer has to address the new memory installed, which can take a short time longer, depending on how much new memory was installed. If it is taking considerably longer, remove and reseat the memory modul...
Please Note: Microsoft Windows 32-bit Operating Systems do not report more than 4GB of installed memory. A computer that has 4GB or more of memory will report only 3.84 GB of physical memory. Learn More...
Possibly. Memory modules can be built in a variety of ways. Consult the owner's manual for your computer, to insure your computer can recognize the size of module you installed. Also check our product configurator to make sure you purchased the correct it...
Never installed memory? It's easier than you think... WATCH HOW!
If you're not sure what model your machine is, and don't know where to start to find out, click HERE to read an in depth article on locating this information.
Possibly. Remove the memory and see if the problem persists. Reseat the memory module into the socket and see if that solves the problem. Try rearranging the order of the memory in the machine. Some computer power supplies don't output enough power (or ot...
MEMORY MODULES INSERTED BACKWARDS WILL SERIOUSLY DAMAGE THE MOTHERBOARD AND MEMORY. If the notches along the edge with the gold connectors are off, then you probably have an incorrect module. Make sure you are orienting the memory module correctly to the ...
You should be prompted to enter the Setup menu or system BIOS. Enter the BIOS, then immediately save changes and exit (usually by using the F10 key). That should solve the problem.
